Zone2 Speaker Out Connections; Connecting The Power Supply Cord - Denon AVR-1507 Operating Instructions Manual

ENGLISH
Connecting Other Sources

ZONE2 speaker out connections

• When the surround back's power amplifier is assigned to the ZONE2 output channel at Power Amplifier
Assignment mode, the surround back speaker terminals can be used as the ZONE2 speaker out
terminals ( page 42).
• The connections diagram below is an example for when the surround back speaker is assigned to the
ZONE2 stereo 2 channel.
In this case, surround back speaker out can not be used for MAIN ZONE.
Subwoofer
Connection terminal for
subwoofer with built-in
amplifier.
IN
( L ) ( R )
< > > <
Front speakers
(B)
Center Surround
speaker speakers
( L ) ( R )
> < >
> <
( L ) ( R )
( L ) ( R )
< > > <
> < >
Front speakers ZONE2 Front
(A) speaker
ZONE2

Connecting the power supply cord

<
NOTE:
• Insert the plugs securely. Incomplete connections will result in the generation of noise.
• Only use the AC OUTLETS for audio equipment. Never use it for hair driers, monitors or other
electrical appliances.
<
15
ENGLISH
Connecting Other Sources
AC outlet
(wall)
AC 120 V, 60 Hz
AC OUTLETS
• SWITCHED (total capacity – 120 W (1A.))
The power to the outlet is turned on and off in
conjunction with the POWER switch on the
main unit, and when the power is switched
between on and standby from the remote
control unit.
No power is supplied from this outlet when
this unit's power is at standby. Never connect
equipment whose total power consumption
exceeds 120 W (1A.).