Telefunken HappyCare HCCV5 Instruction Manual page 26

2. Steam ironing
 Put the iron on the steam station iron's thermal insulating cushion.
 Connect the plug to wall outlet. Press on the button
generator, the power indicator
 Turn temperature dial to your desired setting, which is depended on the fabric of garment, refer
to IRONING TIPS latter. The soleplate starts to be heated up and the working indicator begins to
illuminate.
 When the working indicator changes from illuminating to off, it means the selected temperature
is reached and you now can start ironing.
WARNING: While in use, do not touch the hot surfaces of the appliance (accessible metal
parts and plastic parts adjacent to the metallic parts) to avoid getting burned!
3. Steam ironing
 Retrieve the water tank from its location, open the water tank filler. Fill in the water tank with a
jug without exceeding the "MAX" level of water indicator then close the water tank filler before
putting the water tank back into its location. Always check that you have well put back the water
tank into its location before starting to use your steam generator.
 Put the iron on the steam station iron's thermal insulating cushion.
 Connect the plug to wall outlet. Press on the button
generator, the power indicator
 Turn the thermostat button, select the setting between « Wool » and « Cotton » to start steam
ironing. The setting on « Synth. » shall not be used for steam ironing as the water may leak from
the iron due to low temperature.
 Press on the steam flow control button to select your level of steam flow.
: Low steam flow
: Average steam flow
: High steam flow (100 gr/min)
The indicator light of your selected steam flow level will flash during the pre-heating phase
(around 2 minutes), then will keep illuminating when the boiler reaches the desired steam
heating. Please note, it's the reverse for the thermostat light located on the iron, it will turn off
to indicate the iron reaches the desired heat.
 Press the steam trigger to release steam for ironing. Do not turn the steam jet towards a person.
 After ironing, you can put the iron the thermal insulating cushion. If there is no steam sprayed
out from the soleplate within 8 minutes, the appliance will be turned off automatically. Remove
the plug from the wall socket. But the soleplate is still hot, never touch it with hand, place it on
the thermal insulating cushion until it cools down completely.
light will turn on.
light will turn on.
On/Off to switch on your steam
On/Off to switch on your steam
ENGLISH
11