Storage - Schedule Settings; Record Schedule - TRENDnet TV-IP329PI User Manual

TRENDnet User's Guide

For your privacy and to better protect your system against security
risks, we strongly recommend the use of strong passwords for all
functions and network devices. The password should be something
of your own choosing (using a minimum of 8 characters, including
at least three of the following categories: upper case letters, lower
case letters, numbers and special characters) in order to increase
the security of your product.

Proper configuration of all passwords and other security settings is
the responsibility of the installer and/or end‐user.
The Receiver table: Select the receiver to which the email is sent. Up to
3 receivers can be configured.
Receiver: The name of the user to be notified.
Receiver's Address: The email address of user to be notified.
4. Click Save to save the settings.
© Copyright TRENDnet. All Rights Reserved.
Storage – Schedule Settings
Record Schedule
Steps:
1. Check the checkbox of Enable to enable scheduled recording.
2. Click Advanced to set the camera record parameters.

Pre‐record: The time you set to start recording before the scheduled
time or the event. For example, if an alarm triggers recording at 10:00,
and the pre‐record time is set as 5 seconds, the camera starts to
record at 9:59:55.
The Pre‐record time can be configured as No Pre‐record, 5s, 10s, 15s,
20s, 25s, 30s or not limited.

Post‐record: The time you set to stop recording after the scheduled
TV‐IP329PI
37