HP 245 G8 Maintenance And Service Manual page 53

Before removing the heat sink assembly, follow these steps:
1. Prepare the computer for disassembly
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
Remove the heat sink assembly:
1. In the order indicated on the heat sink, remove the four Phillips M2.0 × 4.0 screws (1) that secure the
heat sink to the system board.
2. Remove the heat sink (2) from the system board.
3. Thoroughly clean the thermal material from the surfaces of the heat sink and the system board
components each time the heat sink is removed. Replacement thermal material is included with the heat
sink and system board spare part kits. The following illustration shows the replacement thermal
material locations.
(Preparation for disassembly on page
Computer feet on page
Bottom cover on page
Battery on page 28).
26).
27).
Component replacement procedures
26).
45