Figure 1-7. Removing The Control Panel Tray - Dell PowerEdge 8450 Upgrade Manual
Microprocessor board
Hide thumbs
Also See for PowerEdge 8450:
- Installation manual (140 pages) ,
- Information update (40 pages) ,
- Information update (32 pages)
Table of Contents
Advertisement
Available languages
Available languages
1-10
Microprocessor Board Upgrade Guide
10. To remove the control panel tray, perform the following steps:
a.
Using the 1/4-inch nut driver, remove the ten screws securing the micropro-
cessor cage and the control panel tray to the chassis (see Figure 1-7).
control
panel tray
tray extractor levers (2)
Figure 1-7. Removing the Control Panel Tray
b.
Rotate the two tray extractor levers on each side of the control panel tray
toward you (see Figure 1-7).
c.
Pull the control panel tray forward to clear it from the chassis, and place the
tray on a clean antistatic mat.
microprocessor cage
screws (10)
Advertisement
Chapters
Table of Contents
