Activate/Deactivate Time Alarm; Snooze Alarm; Projection Not Working; Projection Adjustments - La Crosse Technology 616-143V2 Faqs

2. MINUTES: The Minutes will flash, use the ARROW buttons to set the minutes, and press TIME
ALARM button to confirm.
3. Press the SETTINGS button to return to normal mode.
Note: When no buttons are pressed for ten seconds, the projection alarm will save the last change and
default back to normal mode

Activate/Deactivate time alarm

 In normal mode, press and release the TIME ALARM button once to show alarm time.
 Press and release the TIME ALARM button repeatedly to turn ON/OFF alarm.
 The alarm icon appears when alarm is active.
 Note: The alarm will ring for 2 minutes then turn off if no buttons are pressed.

Snooze Alarm

 When the alarm sounds, press the HI/LOW/OFF button to snooze the alarm for 10 minutes.
 The snooze option can repeat three times.
 The alarm icon will flash while the snooze feature is active.
 Note: while the alarm sounds press any button except the TIME ALARM button to turn the alarm off.

Projection not working

Projection only shows when SNOOZE/LIGHT button is pressed:
 Check the Projection ON/OFF switch, to be sure it is in the ON position.
 Check that the a/c cord is properly plugged in. Line it up and push it in. Once you are sure it is in
correctly, remove the batteries. If the display goes blank, the a/c cord needs adjustment.

Projection Adjustments

When operating on A/C power the projection will display constantly unless projection is turned off or when
the clock is searching for WWVB signal.
Operating on a/c power:
• Projection ON/OFF: Use the PROJECTION ON/OFF slide switch on the back of the clock to turn
the projection off when operating on a/c power.
Rotate Projection: Press and release the PROJECTION/DIRECTION button to rotate projection
•
image 180 degrees as viewed on the wall or ceiling.
Focus Projection: Use the focus wheel on the projection arm to adjust the clarity of the
•
projection on the wall or ceiling.
Time/Outdoor Temperature Projection: The projection will alternate between time and
•
outdoor temperature every 5 seconds. This projection cannot change to just time or just
temperature. The projection will always alternate.
Operating on battery power only:
Press and release the SNOOZE/LIGHT button on top of the Atomic Projection Alarm to show the
projection for 5 seconds.
Note: Projection will not display constantly when operating on battery power.

Daylight Saving Time

 Dependent on your location, position of the clock in your home, and atmospheric interference, it may
take up to 5 nights for the change from Daylight Savings Time to Standard Time and vice-versa to
occur.
 Check for a WWVB Tower Icon showing on your Clock. The tower icon indicates you have received
the WWVB signal from Ft Collins CO in the past 24-hours.
 Check that the clock is in the correct
 Check whether the DST indicator is ON or OFF. If the indicator is OFF the clock will not change.
 Check for fresh batteries. Without proper batteries, the antenna will have a harder time picking up
the signal.
La Crosse Technology, Ltd.
Time Zone.
www.lacrossetechnology.com/support Page 8