Step 3- Access Point Quick Setup In Standalone Mode - Quantum QN-H-220 Quick Setup Manual

Management Mode
Quantum Networks' Access Point can be configured in two modes:
Standalone
Independent management of each Access Point
Cloud Controlled
Centralized management of Access Points using QN-RUDDER

Step 3- Access Point Quick Setup in Standalone Mode


Select "Management Mode" as "Standalone", if each Access Point is to be configured
and managed individually. Define username and password for the device and click
"Next".

User can select Access Point's Operation Mode as Bridge or Router.
Description: Difference between Access Point as a Bridge or a Router.

Bridge - In this mode, device connects to a wired or wireless router via an
ethernet cable and extends the wireless coverage of your existing network.

Router - In this mode, device connects to the internet directly and share internet
access to multiple wired and wireless devices. NAT and DHCP servers are
enabled by default
Bridge

Configure WLAN (SSID) parameters and click Next.

Review the Configuration Summary. Click Reconfigure if any changes are
required or click Finish to complete the configuration.
Router

Configure WLAN (SSID) and Local subnet parameters and click Next.

Review the Configuration Summary. Click Reconfigure if any changes are
required or click Finish to complete the configuration.
www.qntmnet.com