Philips 26PF5320/28 Service Manual page 13

To remove the LCD-panel, carry out the following steps:
1. Cautiously pull back the upper parts of the anti-static
copper foils next to the "L" and "R" loudspeakers (see
Figure "Anti-static copper foil"). Do this in such a way that
the foils are no longer attached to the metal ground plate
on which the SSB board is mounted.
2. Disconnect the cables (2) from the "L" and the "R"
loudspeakers (see Figure "Anti-static copper foil").
3. Important: Unplug the LVDS connector (3) on the LCD
panel (see Figure "LVDS connector").
Be careful, as this is a very fragile connector!
4. Unplug the connectors (4) of the Side I/O panel, the Top
Control panel, and the LED panel on the SSB board (see
Figure "SSB board connectors for side I/O, keyboard
control, and LED").
5. Unplug the X520 and X530 connectors (5) on the Power
Supply board (see Figure " Connectors X520 and X530 on
power supply panel"). Instead of X520, also connector 66B
(6) on the other end of the flatcable can be unplugged (see
Figure "Connector 66B on LCD panel").
6. Lift the metal frame (together with all PWBs) from the LCD
panel.
Take care not to damage the fragile LVDS cable, the
66B connector and the anti-static copper foils near the
"L" and "R" loudspeakers (take care of this too when
later re-assembling the TV set and replacing the
copper foil).
7. After removal of the metal frame, you can lift the LCD
display (7) from its plastic frame (see Figure "LCD panel").
8. If the plastic frame is damaged, replace it by a new frame,
after removing the loudspeakers, the Side I/O panel, the
Top Control panel, and the LED panel.
Mechanical Instructions
4.4 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
• While re-assembling, make sure that all cables are placed
and connected in their original positions. See Figure "Cable
dressing". Also make sure that the anti-static copper foils
are not damaged and that they make good electrical
contact with the metal frame. Be careful with the fragile
LVDS cable.
LC4.3U AA 4. EN 13