Philips 26PF5320/28 Service Manual page 10

EN 10 4. LC4.3U AA
4.3.5 SSB Board Cover Shield (depending on model)
Figure 4-7 Cable clip on cover shield
Figure 4-8 SSB board cover shield
1. Release the cable from the plastic cable clip (1) on the
shield (see Figure "Cable clip on cover shield" above).
2. Remove the four fixation screws (2, see Figure "SSB board
cover shield"; the screws are also indicated by arrows on
the shield) and remove the shield.
Notice that on one side, the shield is not only held by two
screws, but also by two brackets (see Figure "Cable clip on
cover shield" above).
Mechanical Instructions
1
F_15270_044.eps
180505
2
2
F_15270_045.eps
190505
4.3.6 SSB Board
1
Figure 4-9 SSB board connectors
3
Figure 4-10 VGA connector screws
1. Very cautiously disconnect the LVDS cable (1) from the
panel (see Figure "SSB board connectors"). Notice that this
cable is very fragile.
2. Disconnect the six remaining cables (2) from the panel.
3. Remove the fixation screws that secure the SSB board
(depending on model) and also the six fixation screws (3)
from the VGA connector and the cinch connectors on the
SSB board (see Figure "VGA connector screws").
4. Take the panel out of its brackets.
2
2
F_15270_073.eps
260505
3
F_15270_075.eps
260505