Husqvarna Automower 430XH Operator's Manual page 28

4. Push the OK button.
3.12.2.6 Security level
There are 3 security levels for the product.
Function Low
Alarm
PIN-code
Time lock X
• Alarm - An alarm goes off if the PIN-code is
not entered within 10 seconds after the
STOP button is pushed. The alarm also
goes off when the product is lifted. The
alarm stops when the PIN-code is entered.
• PIN-code - The correct PIN-code must be
entered to get access to the Menu structure
of the product. If the incorrect PIN-code is
entered 5 times, the product is locked for a
time. The lock is extended for each new
incorrect try.
• Time lock - The product locks if the PIN-
code has not been entered in 30 days. Enter
the PIN-code to get access to the product.
To set the security level
Select 1 of 3 security levels for your product.
To get access to the menu
1. Do steps 1–3 in
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Security > Security level .
3. Use the arrow buttons and the OK button to
select the level of security.
4. Push the OK button.
To create a New loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if two
adjacent installations have a very similar signal.
1. Place the product in the charging station.
To get access to the menu
2. Do steps 1–3 in
on page 26 .
28 - Installation
3.
4.
To change the PIN-code
1.
Medium High
2.
X
X X
3.
X X
4.
5.
6.
7.
To change the duration of the alarm
1.
2.
3.
4.
To change the duration of the time lock
1.
2.
Settings >
3.
4.
3.12.2.7 Messages
In this menu the previous fault and information
messages can be found. For some of the
messages, there are tips and advice to help to
rectify the fault. Refer to
44 .
Use the arrow buttons and the OK button to
move through the menu structure
Advanced > New loop signal .
Await confirmation that the loop signal has
been generated. This normally takes about
10 seconds.
To get access to the menu
Do steps 1–3 in
on page 26 .
Use the arrow buttons and the OK button to
move through the menu structure
Security > Advanced > Change PIN-code .
Enter the new PIN code.
Push the OK button.
Enter the new PIN code.
Push the OK button.
Make a note of the new PIN code. Refer to
Introduction on page 3 .
To get access to the menu
Do steps 1–3 in
on page 26 .
Use the arrow buttons and the OK button to
move through the menu structure
Advanced > Duration > Duration of alarm .
Use the arrow buttons to select a time
interval of 1 to 20 minutes.
Push the BACK button.
To get access to the menu
Do steps 1–3 in
on page 26 .
Use the arrow buttons and the OK button to
move through the menu structure
Advanced > Duration > Duration of time
lock .
Use the number buttons to select a time
interval of 1–90 days.
Push the BACK button.
Troubleshooting on page
1230 - 002 - 30.03.2020
Security >
Settings >
Security >
Security >