Datavideo DAC-100 Getting Started page 9

C. Diagrams of typical cable connections
Make sure your VCR or Analog source is connected to the front inputs of the DAC-100 (LED's
are on the front of the DAC-100).
A 6-pin FireWire cable can be connected to the front or rear of the DAC-100. The
opposite end should be connected to your 1394/connector on your computer.
If you would like to monitor your video, a composite video cable can be used to connect a
video monitor. Connect a composite RCA cable from the rear of the DAC-100 and connect the
opposite end to the input of your monitor.
Note: S-video cables only carry a video signal, so you will need to connect your RCA audio
cables to the converter to capture sound.