Woods Batwing BW15.70E Operator's Manual page 48

REF PART QTY
A 1045853 - WINCH KIT, COMPLETE
1 1045858RP 2 WINCH UPRIGHT
2 1045859RP 1 WINCH MOUNT CHANNEL
3 1045856RP 1 WINCH TIE LINK
4 62153 11 .375 NC X 1 HEX FLANGE SCREW
5 1045628 13 3/8 NC FLANGE NUT
6 1033958 2 9.5 mm X 31.75 mm HEX FLANGE
SCREW
7 11789 2 CABLE CLAMP
8 11790 1 CABLE HOOK
9 N/S 1 1/4" X 24 FT CABLE
10 N/S 1 CLAMP KIT
11 12612 1 WINCH
12 409 2 CLEVIS PIN 12.7 mm x 50.8 mm
13 22411 2 KLIK PIN, 3/16 X 1
14 6696 2 CHAIN IDLER CASTING
15 N/S 4 IDLER BRACKET
16 1031225 8 HFS .50NC X 1 .25 GR5
17 1045624 8 NUT, HFN 1/2 NC, DRI-LOC PATCH
N/S NOT SERVICED
48 Parts
WINCH KIT (OPTIONAL)
DESCRIPTION
Winch Kit Installation
1. Locate and drill one 9/16" hole in each wing as
shown. Assemble items 15, 14, 12 and 13 and
use to locate and drill remaining holes.
2. Secure idler brackets (15) and rollers (14) to deck
with bolts (16) and nuts (17).
3. Assemble uprights (1) to cylinder lugs using
existing pins.
4. Assemble winch assembly to uprights (10) using
bolts (5) and lock nuts (6).
5. Tighten all hardware.
Winch Kit Operation
1. Move cutter so wing is on the up slope of a ditch
to aid in wing lift with the winch.
2. Unwind cable and remove roller (14).
3. Place cable around roller (14) and reinstall using
pin (12) and Klik pin (13).
4. Connect C-Hook (8) to winch mount (2).
5. Remove cylinder pin from clevis end and raise
slowly with winch.
6. Install transport lock before moving unit.
MAN1258 (3/26/2018)