DeLonghi EO141150 Manual page 26

ERROR
MESSAGE ON DESCRIPTION
DISPLAY
E0:28 Electronic control cool-
Err ing system problem
E0:29 Electronic control cool-
Err ing system problem
POSSIBLE PROBLEMS
Oven will not switch ON
LCD display light has gone
out
Clock setting has gone out
Oven lamp is OFF while oven
is ON
The pizza does not cook
evenly
Steam coming out from
housing
Water dripping on internal
glass
POSSIBLE
PROBLEMS
The electronic control
detected a malfunc-
tion on its automatic
cooling system
The electronic control
detected a malfunc-
tion on its automatic
cooling system
• Check that the power plug is properly inserted into wall outlet
• Insert the power plug into a different outlet
• Verify the circuit breaker
If above solution do not solve the problem , probably the oven had a malfunction. Contact a
De'Longhi customer service.
The oven goes in standby mode , when not used for 120 seconds , if Clock was not set.
When Clock is set , the display light is kept ON
If the LCD display light has gone out even if Clock was previously set , a power supply interruption
greater than 5 seconds occurred. The electronic control has been reset. Set the Clock again.
• The bulb is broken. Replace the bulb.
• The bulb is not properly screwed into its housing. Verify that it is completely screwed.
If above solution do not solve the problem , probably the electronic control of the lamp had a
malfunction. Contact a De'Longhi customer service.
Some large pizza , or particular dough pizza may brow unevenly .We suggest in these cases to
turn half way through the cooking time the pizza for a perfect final result.
This is normal. The oven is vented to release excessive steam created from bread or high-moisture
content foods.
This is normal. The condensation created by toasting bred and frozen bred will run down the
inside of door glass , and collected into a special slot on internal lower side of door.
Record the error number.
Disconnect the plug from wall outlet.
Check that vent openings located on bottom side or top
side of the oven are not obstructed by foreign objects
such as fabrics , papers or similar.
Remove any material from supporting surface where the
oven is located or from top side of the oven cover.
If above case was not , and same error occur again , the
electronic control could be damaged. Contact a De'Long-
hi customer service reporting the error number.
Record the error number.
Disconnect the plug from wall outlet.
Check that vent openings located on bottom side or top
side of the oven are not obstructed by foreign objects
such as fabrics , papers or similar.
Remove any material from supporting surface where the
oven is located or from top side of the oven cover.
If above case was not , and same error occur again , the
electronic control could be damaged. Contact a De'Lon-
ghi customer service reporting the error number.
SOLUTION
25
SOLUTION