Adjusting The Water Softener; The Water Hardness Table; Activating The Acoustic Signal For The End Of Programme - Zanussi ZDT22004FA User Manual

• The activation or the deactivation of the acoustic signal for the end of programme.
• The activation or the deactivation of AirDry.
As the appliance stores the saved settings, there is no need to configure it before every cycle.

ADJUSTING THE WATER SOFTENER

1. While the appliance is in user mode, wait until the indicators
• The indicator
• The current setting is indicated by the number of flashes of the indicator
pause + 5 flashes... = level 5).
2. Press the programme button to change the setting. Each pressing of the programme button increases
the level number. After reaching level 10, the count starts again from level 1.
3. Press the on/off button to confirm the setting.

THE WATER HARDNESS TABLE

German degrees French degrees
(°dH)
47 -50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting
2) Do not use salt at this level.

ACTIVATING THE ACOUSTIC SIGNAL FOR THE END OF PROGRAMME

By default, the acoustic signal is deactivated but it is possible to activate it.
While the appliance is in user mode, within about 5 seconds:
1. Press the programme button.
• The indicators
• The indicator
2. Wait until the indicators
• The indicator
3. Press the programme button to change the setting.
• The indicator
4. Press the on/off button to confirm the setting.
38
still flashes.
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
and are on.
flashes.
and are off.
is off = the acoustic signal is deactivated.
is on = the acoustic signal is activated.
and
mmol/l Clarke degrees
8.4 - 9.0
7.6 - 8.3
6.5 - 7.5
5.1 - 6.4
4.0 - 5.0
3.3 - 3.9
2.6 - 3.2
1.9 - 2.5
0.7 - 1.8
<0.7
are off.
(e.g. 5 flashes +
Water softener
level
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
10
9
8
7
6
1)
5
4
3
2
2)
1