AEG AHB82221LW User Manual page 13

Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The lid is not closed proper-
ly.
The FROSTMATIC function
is switched on.
The lid is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
The FROSTMATIC function
is switched on.
The temperature regulator is
not set correctly.
The lid is not closed correct-
ly.
The products' temperature
is too high.
Many products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The lid has been opened of-
ten.
The FROSTMATIC function
is switched on.
Products to be frozen are
placed too closely to each
other.
ENGLISH
Solution
Check if the lid closes well
and the gaskets are undam-
aged and clean.
Refer to "FROSTMATIC
function".
Refer to "Opening and clos-
ing the lid".
Position the water drainage
plug in the correct way.
Refer to "Operation" chap-
ter.
The compressor starts after a
period of time.
Refer to "FROSTMATIC
function".
Set a higher/lower tempera-
ture.
Refer to "Opening and clos-
ing the lid".
Let the product temperature
decrease to room tempera-
ture before storage.
Store less products at the
same time.
Defrost the appliance.
Open the lid only if necessa-
ry.
Refer to "FROSTMATIC
function".
Make sure that there is cold
air circulation in the appli-
ance.
13