Two-Point Autoimmobilization; How To Interpret The Led Status Indicator - Clifford Solaris Owner's Manual

Dei clifford solaris car alarms: owners manual

Table of Contents

For other drivers, or to control Clifford G4 systems on your other cars with the same remote, you can buy additional remote controls from any Clifford

Dealer (or direct from the Customer Service Department of your nearest Clifford Headquarters listed on the front cover) and program them into the

system yourself. Your Solaris will respond to as many as four remote controls.

NOTE: Clifford G4 systems will respond only to G4-type ACG 2 remote controls. Older Clifford ACG and non-ACG

remote controls are not compatible with G4 systems.

To add a new master 5-button remote control, use the Add new master remote feature (column 1, row 1) of the User-selectable features table. To add a new

companion 4-button remote, program each button and button combination to the specific functions noted in column 4.

While armed, your system immobilizes both the starter and ignition systems of your vehicle to prevent a thief from starting the engine. The engine will

remain immobilized even if a thief were to cut power to the system or find and remove the system control unit.

Clifford's optional Wireless Immobilizer interrupts a third point in the vehicle, such as the fuel pump. This Clifford innovation provides immobilization

without any wires to the control unit, so a thief could not find the Wireless Immobilizer even if he tried tracing the system wires! Operation of the

Wireless Immobilizer is automatic and user-transparent.

BE sure to keep the record your Clifford installer provides as to the location of the Wireless Immobilizer in case your

vehicle needs future servicing.

NOTE: If your vehicle's engine ever stalls, the Wireless Immobilizer WILL engage. You must turn the ignition all the

way to "OFF" in order to restart.

With FACT (False Alarm Control and Test), you'll never experience repeated false alarms. If the siren sounds, DO NOT disarm; allow it to run for the

full siren duration. Before sounding the siren a second time, the system automatically checks for another activated sensor or trigger to verify that an

intrusion is in progress. This feature is user-selectable.

The LED on your car's dashboard or console will inform you of the system status:

LED Condition

To conserve vehicle battery power (the LED actually draws more current than the entire control unit), if the system has remained continuously armed for

48 hours, the flash rate will automatically slow to half the normal rate. After 96 hours, it slows to one-quarter.

If this feature is enabled and you forget to remotely arm, the system automatically arms itself 30 seconds after the vehicle doors are closed. For your

convenience, if you re-open any door(s) within the 30-second countdown, AutoArming restarts the 30-second delay from the beginning after all doors are

closed. Solaris has these additional features:

feature and AutoArming are turned on, it allows you to enter the car (if it previously AutoArmed) and silently disarm the system by turning on the

ignition within 15 seconds of opening the door. See User-selectable features (column 3, row 3).

confirm the AutoArming countdown is progressing. Then, 25 seconds later, the system will AutoArm.

AutoArming. To change this setting, see User-selectable features.

AutoArming. To activate Instant AutoArming Bypass, rapidly turn the ignition switch to "ON" then "OFF." You will hear a siren chirp to confirm

that the system will not AutoArm. The system automatically reverts to its normal operating mode when you next start the engine.

Adding new remote controls