BT Hub Phone 1010 User Manual page 8

Hub Phone 1010 [3]DkBlue
Getting started
8
IMPORTANT
The hub must be plugged into the
mains power socket at all times.
Do not connect the phone until the
handset is fully charged.
Talk/Standby time
In ideal conditions, the handset
batteries should give about 10
hours talk time in normal talk time
or 7 hours talk time in Hi-Definition
Sound or 100 hours standby time
on a single charge. The base must
remain plugged in to the mains and
switched on at all times.
Note that new batteries do not
reach full capacity until they have
been in normal use for several days.
Battery symbols
– Battery charged
– Battery half charged
– Battery low
Battery low warning
If the battery charge becomes low
during a call you will hear a warning
beep every minute (provided the
battery warning tone is set to on,
13/4/06 5:44 pm
Hub Phone 1010 – Edition 3 – 13.04.06 – 7451
Place the handset in the base to charge, you hear a beep
tone and the
You should charge the handset for at least 16 hours on
first charge.
2. Put the phone and charging cradle into the front of the
home hub. You will need to remove the front plate from
the hub.
See diagram on the next page for reference.
Page 8
icon begins scrolling.