BT Hub Phone 1010 User Manual page 11

Hub Phone 1010 [3]DkBlue
Handset Registered
association by pressing
idle.
If the handset does not locate the base, it goes back to
idle mode. Try again by changing the base number and
make sure there are no interferences in the environment.
If the handset emits a double beep, it means that the
PIN code is wrong or the base has already 5 subscribed
handsets.
The handset searches for a link with the hub and then
the display goes into standby mode:
13/4/06 5:44 pm
Hub Phone 1010 – Edition 3 – 13.04.06 – 7451
is displayed. Validate the base
and the handset goes back to
Page 11
When a handset is associated with
a base, a number is attributed to
the handset by the base. This
number is displayed on the handset
after the name and must be used
for internal calls.
Getting started
11