How To In Ter Pret The Chirps And In Di Ca Tor Light Flashes; Smart Au Totest Ing; Spe Cific Mal Func Tion Iden Ti Fi Ca Tion - Clifford Concept 300UK How To Use Manual

How to in ter pret the chirps and in di ca tor light flashes

When you use the remote control, the system responds with chirps (unless the chirp muting
feature is turned on) and indicator light flashes. These chirp/flash acknowledgments mean:
Chirps/flashes
You have disarmed the system
1
OR (flash only) you have remotely exited valet mode (see page 12)
You have armed the system
2
OR (flashes only) you have remotely entered valet mode (see page 12)
Armed but there is a door open (if there was a 5-sec. Delay)
2 and then 4
OR the sensor is malfunctioning (if there was a 10-sec. delay) (see Smart
AutoTesting below)
Disarmed but there was an intrusion attempt whilst you were away
3
(see Smart prior intrusion attempt on page 15)
Armed but the bonnet or boot is ajar (see Smart AutoTesting below) or
4
(flashes only) confirms remote override of the Proximity Sensor (see page 13)
Each time you remotely arm the system, it tests all triggers and sensors. If the bonnet or
boot is open when you remotely arm, the system will immediately alert you of the
problem by sounding 4 chirps and 4 indicator light flashes instead of the usual 2 and 2. If
a door is ajar, you will receive the usual 2 chirps and flashes, then, 5 seconds later, there
will be 4 chirps and 4 flashes. (This door ajar warning will not work on vehicles that
have factory-delayed courtesy lights). If a sensor is malfunctioning, you will receive the
usual 2 chirps and 2 flashes, then, 10 seconds later, there will be 4 chirps and 4 flashes.
NOTE: Since this is a warn ing in di ca tion, you will hear the 4 chirps even if you
use the chirp muting feature.

Spe cific mal func tion iden ti fi ca tion

The system can also indicate the specific trigger or sensor that is malfunctioning. If you
get the 4-chirp/4-flash signal upon arming, perform the following to identify the
malfunctioning trigger or sensor:
1. Remotely disarm, then turn on the ignition. The LED status indicator inside your
vehicle will be flashing, pause, then repeat.
2. Count the number of flashes in one cycle between pauses (for your convenience, the
flash cycle repeats a total of 5 times) and refer to the chart below:
LED flashes
1 flash
Activation of Proximity Sensor
2 flashes
Activation of optional vibration/impact or tilt/motion sensor
4 flashes*
Door open/ajar
5 flashes
Boot/bonnet open/ajar (boot only if you have the IntelliStart 4** option)
6 flashes
Bonnet open/ajar (only if you have the IntelliStart 4** option)
7 flashes
Ignition switch was turned on whilst the system was armed
8 flashes
Three or more incorrect valet codes were entered
10 flashes Power tampering or the vehicle battery is very low
* If your ve hi cle has a factory- installed fea ture that turns off or dims the in te rior cour tesy lights
Meaning

Smart Au toTest ing™

Meaning
sev eral sec onds af ter you exit the ve hi cle, the sys tem can not pro vide this in di ca tion.
** This feature/accessory is not evaluated by Thatcham.
14