Advertisement
To Activate Valet Mode.
1. Turn the ignition key to the "ON" position.
2. Flick the valet switch to the "ON" position.
3. Turn the ignition key "OFF." The LED will turn on solid red to indicate the
system is in Valet Mode.
To Deactivate Valet Mode
1. Turn the ignition key to the "ON" position.
2. Flick the valet switch to the "OFF" position.
3. Turn the ignition key "OFF." The LED will turn off and then begin to flash
in a slow, steady pulse to indicate the system is arming.
Optional Horn Honk Output
While the system is activated (armed), if someone attempts to start the engine
without deactivating the Immobilizer first, the vehicle horn will pulse on and
off to attract attention to the vehicle. (This feature may require additional parts
and labor.)
Adding/Deleting Coded Keys
1. Turn the ignition key to the "ON" position.
2. Flick the valet switch to the "ON" position.
3. Turn the ignition key to the "OFF" position.
4. Within 15 seconds, turn the ignition key ON, then OFF 5 times. The LED
will flash rapidly to indicate the system is now in the programming mode.
5. Within 10 seconds, insert and remove the new coded key into the
under-dash receptacle.
6. Within 10 seconds, insert and remove any additional key you wish to
operate the Immobilizer. (You can add up to 4 coded keys to your
Immobilizer.)
7. To exit programming, turn the ignition key to the "ON" position or wait 10
seconds and the Immobilizer will automatically exit programming.
8. In the event of a lost or stolen coded key, repeat steps 5 & 6 four times.
This will automatically erase the missing coded key from memory.
© 1999 Avital Technologies, Inc.
2
Part Number: 31-3310
Advertisement
