Table of Contents
Advertisement
p p o o w w e e r r s s a a v v e e r r m m o o d d e e
Your system will automatically enter Power Saver Mode while
armed or in Valet
operation has been performed. This lowers the current draw on
the vehicle's battery. Power Saver Mode takes over under the
following conditions:
Power Saver when the system is armed: After the system has
been armed for 24 hours the LED will flash at half its
normal rate, decreasing the system's current draw.
Power Saver in Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a one hour period while the
system is in Valet
system remains in Valet
the next time the ignition is turned on and then back off.
p p r r o o g g r r a a m m m m i i n n g g o o p p t t i i o o n n s s
Programming options control your system's normal, operational
set-up. Most options do not require additional parts, but some
may require installation labor.
The following is a list of the programmable options, with the
factory settings in Bold.
A A c c t t i i v v e e arming (transceiver only) or passive arming (auto-
matic arming 30 seconds after the last door has been closed).
© 2003 directed electronics, inc.
Mode, after a period of time in which no
®
Mode: When the system enters Valet
®
Mode, the LED will shut off. If the
®
Mode, the LED will come back on
®
®
43
Advertisement
Table of Contents
