Panasonic KX-HNC850 Information And Troubleshooting Manual page 18

Problem
When initial setup The camera's
is performed LED indicator is
using a WPS blinking in red�
button (Easy
Setup)‚ the
following screen
The camera's
is displayed and
LED indicator is lit
the setup cannot
in yellow�
be completed�
The camera's LED
indicator is lit in
blue�
18
HNC850_ITG_(en-en)_0208_ver.070.pdf
Cause
The DHCP function
of your wireless
router may be
disabled�
The camera is not in
WPS mode�
SETUP
The button
was not pressed for
long enough�
The WPS button
was pressed on
another router
which is different
from the router your
mobile device is
connected with�
The "Isolation"
function on the
wireless router is
enabled�
18
Solution
Confi rm that the wireless router's DHCP settings
are enabled� Refer to your wireless router's
manual�
• Unplug the camera and then plug it in again‚
and then try again from the beginning�
Follow the on-screen instructions‚ and press and
SETUP
hold the button on the camera until it
beeps (about 5 seconds)�
• Reconnect your mobile device to the router
whose WPS button was pressed‚ restart the
HomeHawk
[ ] app‚ and then follow the on-
screen instructions�
Sometimes when the "Isolation" function
is enabled‚ the camera will not be able to
communicate with your mobile device via your
wireless router. Disable the "Isolation" function
on your wireless router. For details‚ refer to your
wireless router's manual�
2019/02/08 17:02:24