Miele H 7164 B Operating And Installation Instructions page 92

Problem solving guide
Problem
Spots like rust appear
on catalytic enamelled
surfaces.
The FlexiClip runners do
not push in or pull out
smoothly.
The oven interior
lighting switches off
after a short time.
The oven interior
lighting is off.
92
Cause and remedy
The catalytic cleaning process does not remove
spices, sugar and similar deposits.
 Take the catalytic enamelled panels out of the
oven and remove this type of deposit with a mild
solution of hot water and washing-up liquid
applied with a soft brush (see "Cleaning and care –
Cleaning catalytic enamelled panels").
The bearings in the FlexiClip runners are not
sufficiently lubricated.
 Lubricate the bearings with the special Miele
lubricant.
Only the special Miele lubricant is designed for the
high temperatures in the oven compartment. Other
lubricants may resinify when heated and will gum
up the FlexiClip runners. You can obtain the
special Miele lubricant from your Miele dealer or
from the Miele Customer Service Department.
You have selected the
setting.
 If you want the oven interior lighting to be
switched on during the entire cooking programme,
select the
Lighting
You have selected the
 Press the  sensor control to switch on the oven
interior lighting for 15 seconds.
 If required, select the
seconds setting.
Lighting | "On" for 15 seconds
| setting.
On
| setting.
Lighting Off
| or
Lighting On "On" for 15