BT Freestyle 1025 User Manual page 17

To switch from pulse to tone dialling
If you are connected to a pulse dialling
exchange, you can still use services
such as phone banking that require
tone dialling.
Call the telephone number you require
KEYPAD
in pulse mode as usual.
When you have been connected, press
the button on the keypad to set
your telephone to tone dialling for the
duration of the call.
When you hang up, your Freestyle 1025
will automatically switch back to pulse
dialling.
To page the handset
If you misplace the handset, you can
use to find it again.
PAGE
Press the
PAGE
Page
The handset will beep. The
on the base flashes.
Stop the handset beeping by pressing
Page
the button again
PAGE
or
the button on the handset. (Please
TALK
note: pressing the
off the line, you will then need to put the
handset back onto the base unit.)
button on the base.
light
IN USE
button will cut
TALK
To insert a pause
With some switchboards, after dialling
the access code you may have to wait
for a moment while the switchboard
picks up an outside line. If so, press
the button to insert a 2.5 second
Redial
REDIAL
pause before keying in the telephone
number.
To use the recall button
This button signals either time break
R
recall or earth recall depending on the
setting of the dialling mode. If you are
connected to a PBX (Private Branch
Exchange), contact your PBX supplier
for further information.
To set the dialling mode
Press the
QUICKDIAL
Quickdial
standby mode.
Press the button.
1
Press for Tone dialling.
1
Press for Pulse dialling.
2
2
Press the
QUICKDIAL
Quickdial
the setting (you will hear a confirmation
tone). If no instruction is received
during this process within 8 seconds,
there will be a beep and the process
will be cancelled before returning to
standby mode.
button during
button to finish
13