Siemens SICAM P37 Manual page 29

Key Setting Parameters
1. Key functions at parameter setting mode
Key symbol
Function
1.Press "
again to alter parameters. Pressing "
SICAM P37, 3-phase Harmonic Power Meter, User Manual
E50417-H8940-C563-4, Release Date 06.2018
▲
a) "▲" to switch digit or flip over;
b) "▼" to move cursor or flip over.
" once after adjusting parameters with "▲" and "▼" to display "Sure", and press "
Example 19:
This screen shows Device ID display items.
At cyclic display mode, press "▲" or "▼" to enter key display
mode, press "
to switch to Device ID display items. Device
ID=000000000001.
Example 20:
This screen shows error code display items.
At cyclic display mode, press "▲" or "▼" to enter key display
mode, and press "
again to switch to error code display items. "E" means fault
prompt, the 7 bits from right to left mean respectively phase A
loss, phase B loss, phase C loss, voltage phase inversion,
phase C reverse, phase B reverse, and phase A reverse. For
example, "E0110001" means phase B and phase C loss and
phase C reverse fault occurs.
▼
a) Press "
setting screen.
b) Press "
setting.
c) Press "
rameter setting
" immediately after "Sure" appears will cancel current alteration.
Operation and Display
" to switch to area B, and press "▲" or "▼"
" to switch to area B. Press "▲" or "▼"
" and " " at the same time to enter
" to enter next menu or "confirm" parameter
" to return to previous menu or "cancel" pa-
1
.
4.3 Key Definition
" once
29