Table of Contents
Advertisement
J.
SSID:
The Service Set
Identifier is the name as-
signed to the wireless
network. The factory SSID
setting is set to default. Make
changes here to match the
SSID on existing Wireless
Router or Access Point.
J
K
L
M
N
O
P
Q
M.
Channel:
By default, the
channel is set to 6. Channel
selection is automatically
determined by the DWL-
AG650 depending on the
channel setting of the access
point selected for association.
To change the channel
settings, the Wireless Mode
must be set to Ad-hoc.
P.
Power Mode:
By default, Power Mode is
set to Continuous Access Mode. Continu-
ous Access Mode — this default setting
consumes the most power. Maximum
Power Save — this setting consumes the
least power. Power Save — this setting
consumes a moderate amount of power.
K.
Wireless Mode:
The factory setting is
set to Infrastructure.
Ad-Hoc mode is used
for peer-to-peer
networking.
N.
TxRate (11b/g):
You
can adjust the transmission
rate of the 802.11b and
802.11g band to get the
best signal possible
depending on your usage
and your environment.
Q.
Preamble:The
default setting is
set to "Short &
Long Preamble."
The preamble
setting must
match the
preamble setting
of the wireless
router or access
point in order to
connect.
9
L.
Ad-Hoc Band:
Specifies the
wireless bandwidth
used whether
802.11a/b/g when
setting up an Ad-
Hoc network.
R
O.
TxRate (11a):
You
can adjust the transmis-
sion rate of the 802.11a
band to get the best
signal possible de-
pending on your usage
and your environment.
R.
Support Band:
By default, the
adapter will scan &
connect to an
802.11a/b/g
netowrk. You also
have the option to
scan specific types
of wireless
networks.
Advertisement
Table of Contents
