D-Link DWL-AG132 Manual page 17

Using the Configuration Utility
DWL-AG132 User's Manual
Advanced
Ad-Hoc Channel:
All devices in the Ad-Hoc network must be set to the same channel.
You can Enable or Disable the IP Settings portion of your profile
Profile IP Settings:
here. If you select Disable you will need to configure the IP address
information each time you connect to a network. If you select Enable
you will maintain the same IP address information each time you
connect to a network.
Disable - This default setting consumes the most power.
Power Mode:
Enable - This setting consumes the least power.
Launch Utility on Select Enable or Disable.
Startup:
Select the parameters here.
Data Packet
Parameter:
This value should remain at its default setting of 2432. If you
Fragmentation
experience a high packet error rate, you may slightly increase your
Threshold:
Fragmentation Threshold within the value range of 256 to 2432.
Setting the Fragmentation Threshold too low may result in poor
performance.
This value should remain at its default setting of 2432. If inconsistent
RTS Threshold:
data flow is a problem, only a minor modification should be made.
Apply: Click Apply if you have made any changes
17
D-Link Systems, Inc.