D-Link DWL-700AP Manual page 35

DWL-700AP User's Manual
2. The wireless client cannot access the Internet in the Infrastructure
mode.
D-Link Systems, Inc.
Troubleshooting (continued)
Make sure the wireless client is associated and joined with the correct access
point. To check this connection: Right-click on the Local Area Connection
icon in the taskbar> select View Available Wireless Networks. The Connect
to Wireless Network screen will appear. Please make sure you have selected
the correct available network, as shown in the illustrations below.
Note: Screen shots were
taken using Windows XP. Your
screens may look similar.
Check that the IP address assigned to the wireless adapter is within the same
IP address range as the access point and gateway. Since the DWL-700AP has
an IP address of 192.168.0.50, wireless adapters must have an IP address in
the same range, e.g., 192.168.0.x. Each device must have a unique IP address;
no two devices may have the same IP address. The subnet mask must be the
same for all the computers on the network. To check the IP address assigned
to the wireless adapter, double-click on the Local Area Connection icon in
the taskbar > select the Support tab and the IP address will be displayed.
(Please refer to Checking the IP Address in the Networking Basics section
of this manual.)
If it is necessary to assign a static IP address to the wireless adapter, please
refer to the appropriate section in Networking Basics. If you are entering
a DNS server address you must also enter the default gateway address.
(Remember that if you have a DHCP-capable router, you will not need to
assign a static IP address. See Networking Basics: Assigning a Static IP
Address.)
default
default
Troubleshooting
35