D-Link DWL-1000AP+ Manual page 34

Troubleshooting (continued)
7. Why is load balancing not working properly within a group of access
points?
Check that the access points are connected through the ethernet cable.
Please keep in mind that the IAPP (Inter Access Point Protocol) is passed
only through the ethernet connection.
Check that the same Group Name is specified in the setting for each
access point.
8. Why doesn't the back-up access point take over for the primary ac-
cess point when the primary access point is not functioning?
Check that both the primary and the backup access point are connected
to each other as well as the ethernet backbone. (Also, please remember
that IAPP-Inter Access Point Protocol-will not function unless the access
points are connected with an ethernet cable.)
Check that the backup access point is configured with the correct Ethernet
MAC address of the primary access point.
Check that the correct EAP type for 802.1x authentication is selected for
the wireless client. If using certification, check that the correct certifica-
tion is properly installed.
34