Using The Console Cli - D-Link DES-3250TG Reference Manual

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
U
SING THE
The DES-3250TG supports a console management interface that
allows the user to connect to the switch's management agent via
a serial port and a terminal or a computer running a terminal
emulation program. The console can also be used over the
network using the TCP/IP Telnet protocol. The console program
can be used to configure the switch to use an SNMP-based
network management software over the network.
This chapter describes how to use the console interface to
access the switch, change its settings, and monitor its
operation.
Switch configuration settings are saved to non-
volatile RAM using save command. The current
configuration will then be retained in the switch's
NV-RAM, and
rebooted. If the switch is rebooted without using
the save command, the last configuration saved
to NV-RAM will be loaded.
Connecting to the Switch
The console interface is used by connecting the Switch to a
VT100-compatible terminal or a computer running an ordinary
C
ONSOLE
reloaded when the
16
2
CLI
switch is