No Spanning-Tree Configuration Revision; Spanning-Tree Edgeport; No Spanning-Tree Edgeport; Spanning-Tree Forceversion - D-Link DES-3226L Cli Command Reference

68 D-Link DES-3226L Command Line Reference

no spanning-tree configuration revision

This command sets the Configuration Identifier Revision Level the default value of 0.
Format
Mode

spanning-tree edgeport

This command specifies that this port is an Edge Port within the common and internal spanning tree.
This allows this port to transition to Forwarding State without delay.
Format
Mode

no spanning-tree edgeport

This command specifies that this port is not an Edge Port within the common and internal spanning tree.
Format
Mode

spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value. The Force Protocol Version
can be one of the following:
802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality supported)
802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality supported)
802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Default
Format
Mode

no spanning-tree forceversion

This command sets the Force Protocol Version parameter to the default value, i.e. 802.1s.
Format
Mode

spanning-tree forward-time

This command sets the Bridge Forward Delay parameter to a new value for the common and internal
spanning tree. The forward-time value is in seconds within a range of 4 to 30, with the value being
greater than or equal to "(Bridge Max Age / 2) + 1".
Default
Format
Mode
no spanning-tree configuration revision
Global Config
spanning-tree edgeport
Interface Config
no spanning-tree edgeport
Interface Config
802.1s
spanning-tree forceversion <802.1d | 802.1w | 802.1s>
Global Config
no spanning-tree forceversion
Global Config
15
spanning-tree forward-time <4-30>
Global Config