Troubleshooting - D-Link DES-3010GA Cli Manual

Layer 2 switch, managed 8 port 10/100base-tx with gigabit & fiber uplinks
Hide thumbs Also See for DES-3010GA:
Table of Contents

Advertisement

Troubleshooting

This section describes problems that may arise when installing the and how to resolve these issue. This section
includes the following topics:
Problem Management — Provides information about problem management with DES-3010FA/GA.
Troubleshooting Solutions — Provides a list of troubleshooting issues and solutions for using DES-
3010FA/GA.
Problem Management
Problem management includes isolating problems, quantifying the problems, and then applying the solution.
When a problem is detected, the exact nature of the problem must be determined. This includes how the problem
is detected, and what are the possible causes of the problem. With the problem known, the effect of the problem is
recorded with all known results from the problem. Once the problem is quantified, the solution is applied. Solutions
are found either in this chapter, or through customer support. If no solution is found in this chapter, contact Cus-
tomer Support.
Troubleshooting Solutions
Listed below are some possible troubleshooting problems and solutions. These error messages include:
Cannot connect to management using RS-232 serial connection
Cannot connect to switch management using Telnet, HTTP, SNMP, etc.
Self-test exceeds 15 seconds
No connection is established and the port LED is on
Device is in a reboot loop
No connection and the port LED is off
Add and Edit pages do not open.
Lost password.
Copyright © 2005
April 22, 2005
CONFIDENTIAL
Document Classification: Proprietary Information
Page 342

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Des-3010fa

Table of Contents