Assigning And Opening Virtual Server Ports - D-Link DCS-900 Manual

Section 3 - Configuration

Assigning and Opening Virtual Server Ports

2) Open Virtual Server Ports To Enable Remote Image
Viewing
The Virtual Server Ports of your router must be opened
for remote access to your camera. This is also referred
to as port forwarding. Please proceed as follows:
• Select Enabled to enable virtual server settings.
• Select a camera name.
• Enter your camera's Local IP Address in the Private
IP field.
• Select TCP under Protocol Type.
• If you are using the default camera port settings, enter
80 in to the Public and Private Port section.
• Schedule should be set to Always so that the camera images can be accessed at any time.
• In the Virtual Servers List, a check mark appearing before the camera name will indicate that the ports are enabled.
• Click Apply to save your settings.
Note: If you are installing multiple cameras, be sure to open ONE Web port per additional camera installed: port 81,
82, etc. for Web server.
D-Link DCS-900 User Manual 40