Assembly - Gravely 992261 Owner's/Operator's Manual

WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
UNIT ASSEMBLY
Package Contents
Unit, Mower Deck and Literature Pack
Preparation Checklist
Refer to the Owner/Operator manual as
required.
1. Unpack Unit – Remove wrap and
packaging materials.
2. Remove Unit From Container – Open
bypass valves (See To Push The Unit on
page 22).
3. Push unit from container onto a level
surface.
4. Close the bypass valves.
5. Check Tire Pressures – See
Specifications on page 43.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a
tire without the proper
equipment and experience
to perform the job.
• Do not inflate the tires
above the recommended
pressure.
• Do not weld or heat a wheel
and tire assembly. Heat can
cause an increase in air
pressure resulting in an
explosion. Welding can
structurally weaken or
deform the wheel.
• Do not stand in front or over
the tire assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.

ASSEMBLY

6. Locate anti-rattle knobs in literature pack
and install in ROPS uprights on both
sides. Raise Rollover Protection
Structure (ROPS) center bar – See
Rollover Protection Structure (ROPS) on
page 17.
7. Adjust Seat – See Seat Adjustments on
page 19 and Service Position on
page 25.
8. Check Steering Lever Positions – See
Adjusting the Parking Brake on page 33.
9. Charge Battery – Remove battery from
unit and charge (See Battery on
page 29).
10. Check Engine Oil Level – Check and
add oil if needed. See engine manual for
specifications.
11. Check Hydraulic Fluid Level – Check
and add oil if needed. See Check
Hydraulic Fluid Level on page 27.
12. Fill Engine Fuel Tank – Add clean fuel to
the fuel tank. See Filling Fuel Tank on
page 20.
IMPORTANT: Refer to engine manual for fuel
type.
13. Inspect Hardware – Check for loose
hardware.
14. Check Safety Interlock System – Check
to see that the interlock system operates
correctly (See Safety Interlock System
on page 16).
15. Lubrication – Lubricate all fittings per
maintenance label under seat and check
hydrostat oil level (See Maintenance
Schedule on page 23).
16. Remove the discharge chute from
transport position and place in operating
position before use. See Figure 3.
EN - 13
WARNING: FAILURE OF
INTERLOCK together with
improper operation can result in
severe personal injury.