Setting Up - BT 1300 Executive User Manual

Setting up

Please note that your handset is already
registered to the base station.
Situate your product close enough to the
telephone and mains power sockets so that the
cables will reach.
The only way to disconnect the product from
the power supply is to remove the power
adapter from the mains socket. Therefore you
must ensure you plan the location so that the
mains power is easily accessed.
Make sure it is at least 1 metre away from other
electrical products to avoid interference.
Do not situate the product in the bathroom or
other humid areas.
You must thread the power supply and line
cord through the plinth before you connect to
the power supply.
Plug the power supply cable into the socket on
the underside of your base. The power cable
connector and socket are coloured red.
Plug the line cord into the other socket on the
underside of the base marked with a telephone
symbol.
7
Please take care that the power supply and
telephone line cord are connected to the
correct sockets as incorrect placement could
damage your equipment.
Once connected, put the plinth back on the
base to prevent it from rocking on the table.
There are two positions for the plinth when
joining it to the base, both can be used for desk
mounting and one for wall mounting. Position
is for desk mounting only and position
desk or wall mounting (see wall mounting on
page 37).
Hold the black plastic square between thumb
and forefinger and peel off individual feet from
backing sheet as shown. These are to stop your
base from moving and to protect your work
surface.
If you decide on position , place 2 of the
rubber feet on the plinth and 2 on the base.
Plug the power adaptor into the wall socket and
switch on. When the power is switched on, the
button on your base will light up.
is for