Installation; Connection - JVC KD-R571M Instruction Manual

Wiring connection
IMPORTANT
We recommend installing the unit with a commercially
available custom wiring harness specific for your car and
leave this job to professionals for your safety. Consult
your car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
(separately purchased)
Blue: To power antenna
Blue/white: To amplifier
* 2
You can also connect
a subwoofer speaker
directly using this
lead without an
external subwoofer
amplifier. For setting,
10.
Recommended connection
Front output
Rear/subwoofer output
Antenna terminal
To the steering
Light blue/yellow
wheel remote
STEERING
control adapter
WHEEL
REMOTE
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
Brown: Tel muting
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker (right)
Gray/black
White: Front speaker (left)
White/black
Purple: Rear speaker (right)
Purple/black
Green: Rear speaker (left) *
Green/black *
Signal cord
(not supplied)
Fuse (10 A)
Ignition switch
Separate red wire
Make this connection if your
vehicle factory wiring harness
does not have "12 V ignition
switch" wire.
2
2
* 1
Firmly connect the ground wire
of the amplifier to the car's
chassis to avoid damaging the
JVC Amplifier * 1
unit.
Part list for

installation

Remote wire
(not supplied)
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
Car fuse block
(D) Wiring harness
(E) Extraction key
ENGLISH
15