Stihl MS 250 Instruction Manual page 42

English
11
Thread the end of the rope
through the top of the guide
N
bushing (11) and rope rotor (12)
and secure it with a simple
overhand knot.
Go to "Installing the Rope Rotor".
N
40
Models without ElastoStart and models
with Easy2Start
12
Remove the remaining rope from
N
the rotor and starter grip.
Thread the new starter rope through
N
the rotor and secure it with a simple
overhand knot.
Thread the other end of the rope
N
through the rope guide bushing
(from inside) and the underside of
the starter grip and secure it with
one of the special knots shown – do
not wind the rope onto the rotor.
Installing the rope rotor
Models with standard starter
7
8
9
Coat the rope rotor bearing bore
N
with non-resinous oil.
Slip the rotor over the starter post –
N
turn it back and forth to engage the
anchor loop of the rewind spring.
Refit the pawl (9) in the rotor.
N
Fit the washer (8) on the starter
N
post.
Use a screwdriver or suitable pliers
N
to install the spring clip (7) on the
starter post and engage it on the
pawl's peg – the spring clip must
point clockwise as shown in the
illustration.
MS 250