Stihl MS 250 Instruction Manual page 41

Models with Easy2Start
5
6
Use circlip pliers to carefully remove
N
the circlip (2).
Remove the washer (3), driver (4),
N
spring housing (5) and washer (6).
If suitable circlip pliers are not available,
have the starter rope or rewind spring
replaced by your servicing dealer.
Models with standard starter
7
8
9
Remove the spring clip (7).
N
Carefully remove the rope rotor with
N
washer (8) and pawl (9).
MS 250
WARNING
The rewind spring may pop out and
uncoil during this operation – take care
to avoid the risk of injury.
Models with Easy2Start
4
3
Remove the spring clip (7).
N
2
Carefully remove the rope rotor with
N
washer (8) and pawls (9).
WARNING
The rewind spring may pop out and
uncoil during this operation – take care
to avoid the risk of injury.
7
8
9
9
Replacing the starter rope
Models with ElastoStart
10
Pry the cap (10) out of the grip.
N
Remove the remaining rope from
N
the rotor and starter grip.
Thread the new rope through the
N
starter grip and tie a simple
overhand knot. Dimension "a"
should be 4 mm to 7 mm.
Pull the knot back into the grip.
N
Refit the cap in the grip.
N
English
a
39