Craftsman 137.322850 Operator's Manual page 19

INSTALLING THE DUST
COLLECTION ELBOW AND THE
DUST BAG (FIG. C)
1. Install the larger end of the dust
collection elbow (1) onto the
exhaust port (2).
NOTE: The elbow can be used
to attach either the dust bag or a
vacuum hose to remove sawdust
from the work area.
Fig. C
2
Installing the dust bag (Fig. D)
1. Squeeze the metal collar wings (1)
of the dust bag (2).
2. Place the dust bag neck opening
around the dust collection elbow (3),
and release the metal collar wings.
IMPORTANT: Check frequently and
empty bag before it gets full.
Fig. D
3

WARNING
!
Do not use this saw to cut and/or sand
metals. The hot chips or sparks may
ignite sawdust from the bag material.
1
1
2
INSTALLING THE HOLD-DOWN
CLAMP ASSEMBLY (FIG. E, F)
Place the hold-down clamp assembly (1)
in one of the mounting holes (2) located
behind the fence.
Fig. E
2
Fig. F
2
UNLOCKING THE SLIDE CARRIAGE
(FIG. G)
After removing the saw from the carton,
loosen the slide carriage lock knob (1),
located on the left side of the slide
carriage. When transporting or storing
the miter saw, the slide carriage should
always be locked in position.
Fig. G
1
19
1
2