Premaintenance Procedures; Removing And Installing The Engine Hood; Lubrication; Greasing The Bearings - Toro 74353 Operator's Manual

Premaintenance
Procedures
Removing and Installing the
Engine Hood
1. To remove the hood, loosen the knobs and
then pull the hood back and up (Figure 17).
Figure 17
1. Engine hood
2. To install the hood, put the hooks into the
slots and slide forward (Figure 18).
3. Tighten the knobs in the engine hood
(Figure 17).
Figure 18
1. Engine hood

Lubrication

Greasing the Bearings

Grease Type: No. 2 General Purpose Lithium
Base Grease
2. Knob
2. Hook
Grease the front caster pivots and wheels
(Figure 19).
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers to the brake
position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving
the operating position.
3. Clean the grease fittings (Figure 19 and
Figure 20) with a rag. Make sure to scrape any
paint off of the front of the fitting(s).
Figure 19
1. Front caster tire
Figure 20
4. Connect a grease gun to each fitting (Figure 19
and Figure 20). Pump grease into the fittings
until grease begins to ooze out of the bearings.
5. Wipe up any excess grease.

Engine Maintenance

Servicing the Air Cleaner

Foam Element: Clean after every 25 operating
hours, or yearly, whichever occurs first.
21