Premaintenance Procedures; Raising The Seat; Lubrication; Greasing The Bearings - Toro 74833 Operator's Manual

1. Read the Operator's Manual before performing any
maintenance.
2. Check the engine oil every 8 hours
3. Check the drive wheel tire pressure every 25 hours
Premaintenance
Procedures

Raising the Seat

Make sure the motion control levers are locked in the
neutral lock position. Lift the seat forward.
The following components can be accessed by raising
the seat:
• Service decal
• Fuses
• Battery and cables
Figure 32
Located on the seat pan underside
4. Check the hydraulic oil every 25 hours
5. Check the caster wheel tire pressure every 25 hours
6. Lubricate the caster wheel every 25 hours

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all
Grease Type: No. 2 General Purpose Lithium Base
Grease
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers to the neutral lock
position, set the parking brake, stop the engine,
remove the key, and wait for all moving parts to stop
before leaving the operating position.
3. Clean the grease fittings (Figure 33 and Figure 32)
with a rag. Make sure to scrape any paint off of the
front of the fitting(s).
28
lubrication points.