Maintenance; Recommended Maintenance Schedule(S); Premaintenance Procedures; Raising The Seat - Toro 74380 TimeCutter Z4200 Operator's Manual

Hide thumbs Also See for 74380 TimeCutter Z4200:
Table of Contents

Advertisement

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
Before each use or daily
Every 25 hours
Every 100 hours
Every 200 hours
Every 500 hours
Before storage
Yearly
Every 2 years
Important: Refer to your engine operator's manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
Premaintenance
Procedures

Raising the Seat

Make sure the motion control levers are locked in the
park position. Lift the seat forward and lower it to the
floor board.
Maintenance Procedure
• Check the safety interlock system.
• Check the air cleaner for dirty, loose or damaged parts.
• Check the engine oil level.
• Check air intake and cooling areas (clean as necessary).
• Check the cutting blades.
• Clean the mower housing.
• Grease all lubrication points.
• Service the paper element (more often under extremely dusty, dirty conditions)
• Check tire pressure.
• Check the belts for wear/cracks.
• Replace the paper element (more often under extremely dusty, dirty conditions)
• Change the engine oil and filter.
• Clean the blower housing (more often under extremely dusty, dirty conditions).
• Replace the fuel filter.
• Check spark plug condition and gap.
• Replace the spark plug.
• Charge the battery and disconnect battery cables.
• Perform all maintenance procedures listed above before storage.
• Paint any chipped surfaces.
• Change the engine oil and filter.
• Replace the fuel filter.
• Check spark plug condition and gap.
The following components can be accessed by raising
the seat:
• Serial plate
• Service decal
• Seat adjustment knob
• Fuel filter
• Fuses
• Battery cables
21

Advertisement

Table of Contents
loading

Table of Contents