Table of Contents
Advertisement
Figure 62
1. Measure blade at points A
and B
Changing the Deck
Front-to-Rear Pitch
Changing the front-to-rear pitch is done by
adjusting the front height-of-cut posts.
1. To change the front-to-rear pitch, the front
height-of-cut posts can be adjusted (Figure 63).
Figure 63
1. Caster Wheel
2. Carrier Frame
3. Front height-of-cut pins
2. To raise the front of the deck, loosen jam nut
and rotate the front pin clockwise (Figure 63).
2. Measure from a level
surface
4. Jam nut
5. Ball joint
3. To lower the front of the deck, loosen jam
nut and rotate the front pin counter clockwise
(Figure 63).
4. Position the blades front-to-rear. Measure at
C and D locations (Figure 62) from a level
surface to the cutting edge of the blades.
5. Check the side-to-side leveling of the cutting
unit.
6. Tighten the jam nuts (Figure 63).
Checking the Deck
Side-to-Side Leveling
1. Check the tire pressure on both deck and
traction unit.
2. Position the blades side-to-side (Figure 64).
Measure at B and C locations (Figure 64) from
a level surface to the cutting edge of blade tips
(Figure 64).
Figure 64
1. Measure from a level
surface
3. The difference between measurements B and
C should be no more than 1/4 inch (6 mm).
Changing the Side-to-Side
Leveling
Changing the side-to-side leveling is done by
adjusting tire pressure.
44
2. Measure blade at points B
and C
Advertisement
Table of Contents
