Table of Contents
Advertisement
TRENDnet User's Guide
Add IPv6
To add an IPv6 policy, use the following procedure:
Click Add IPv6, The Policy Settings page.
Enter a number in the Policy Index field. The Policy Index is a unique number
within the range of 1 – 65535 which identifies the policy. This field is
mandatory.
Choose the parameters to add for the policy, and enter data one or more of the
parameters required for your policy. They are listed here:
o
VLAN ID - A unique number identifying a VLAN ranging from 1 to 4094.
o
802.1p Priority - 802.1p priority level of the frame ranging from 0 to 7.
o
Protocol - Indicates the packet protocol ranging from 0 to 255.
o
IPv6 Source IP Address - Specifies the IPv6 Source IP address.
o
Prefix Length - Indicates the length of the Source IP ranging from 1-
128.
o
IPv6 Destination IP Address - Specifies the IPv6 Destination IP
address.
o
Prefix Length - Indicates the length of the Destination IP ranging from
1- 128.
o
Source Layer 4 Port - Indicates the source layer 4 port ranging from 1 -
65535.
o
Destination Layer 4 Port - Indicates the destination layer 4 port
ranging from 1 - 65535.
o
Policy Sequence: Enter a number in the Policy Sequence field. The
Policy Sequence must be a unique number within the range of 1 -
65535. This field is mandatory.
o
Policy Action: In the Permit/Deny field, use the pull down menu to
select one of the following parameters:
o
Deny - This selection drops ingress packets that conform to the
specified Replaced-CoS or Replaced-DSCP.
o
Permit - This selection allows ingress packets that conform to the
specified Replaced-CoS or Replaced-DSCP to be processed by the
switch.
Note: You must enter a selection for Deny/Permit field even if the
Profile Action ID that you have entered ignores both the Replaced-
DSCP and Replaced-CoS fields.
© Copyright 2016 TRENDnet. All Rights Reserved.
o
Replaced-CoS: Enter a number in the Replaced-CoS field ranging from
0 to 7. This field indicates the CoS level of interest. This field is not
mandatory and you may elect to leave it blank
o
Replaced-DSCP: Enter a number in the Replaced-DSCP field within the
range of 0 to 63. This field indicates the DSCP level of interest. This
field is not mandatory and you may elect to leave it blank.
o
Rate Control Index: The Rate Control Index is a unique number within
the range of 1 - 65535. This field is mandatory and must match the
Rate Control Settings page.
o
Port List: Select the interface for which you want to display data.
Click Add to add the policy to the Policy Table.
TEG-40128
77
Advertisement
Table of Contents
