Table of Contents
Advertisement
TRENDnet User's Guide
Diagnostic LEDs
Power (PWR) LED
: When the Power LED lights on, the device is receiving
On
power.
: When the Power turns off, the power cord is not
Off
connected or the device is not receiving power.
FAN
On (Red)
: Diagnostic test during device start up.
After device start up, during normal device operation,
error or fault detected in fan operation.
On (Green) : After device start up, during normal device operation, fan
status is ok.
10GBASE-T Ethernet Port LEDs (1-8,11-12)
Link/Activity (per port)
On
: When the Link/ACT LED lights on, the respective port is
successfully connected to an Ethernet network.
Blinking : When the Link/ACT LED is blinking, the port is
transmitting or receiving data on the Ethernet network.
Off
: No link.
© Copyright 2016 TRENDnet. All Rights Reserved.
Speed (per port)
Green
: When the Green LED is on, the respective port is
on
connected to a 10Gbps network.
Amber
: When the Green LED is on, the respective port is
on
connected to a 100Mbps or 1Gbps network.
10G SFP+ Slots (9-10,11F-12F)
SFP
Green on
: When the SFP LED is on, the link established using
the SFP module is operating at 10Gbps speed.
Green blinking : When the SFP LED is blinking, the port is
transmitting or receiving data on through the link
established.
Amber on
When the SFP LED is on, the link established using
the SFP module is operating at 1Gbps speed.
Amber blinking
When the SFP LED is blinking, the port is
transmitting or receiving data on through the link
established.
Off
No link established.
TEG-40128
3
Advertisement
Table of Contents
