Kenwood TK-8360 Service Manual page 36

TK-8360/8360H/8360H
Item Condition
5. DQT 1) TEST CH: Low, Low', Center,
Balance High', High (5 points)
(Narrow) 2) Deviation meter fi lter
LPF: 3kHz
HPF: OFF
3) Transmit
6. Maximum 1) TEST CH: Low, Low', Center,
Deviation High', High (5 points)
(Narrow) 2) Deviation meter fi lter
LPF: 15kHz
HPF: OFF
3) Transmit
7. MIC 1) TEST CH: Center
Sensitivity 2) Deviation meter fi lter
Check LPF: 15kHz
HPF: OFF
3) Transmit
8. DQT 1) TEST CH: Center
Deviation 2) Deviation meter fi lter
(Narrow) LPF: 3kHz
HPF: OFF
AG: 11kHz/5mV
3) Transmit
9. QT 1) TEST CH: Center
Deviation 2) Deviation meter fi lter
(Narrow) LPF: 3kHz
HPF: OFF
3) Transmit
10. DTMF 1) TEST CH: Center
Deviation 2) Deviation meter fi lter
(Narrow) LPF: 15kHz
HPF: OFF
3) Transmit
11. MSK 1) TEST CH: Center
Deviation 2) Deviation meter fi lter
(Narrow) LPF: 15kHz
HPF: OFF
3) Transmit
Receiver Section
Item Condition
1. Sensitivity 1) TEST CH: Low, Low', Center,
(Semiauto- High', High (5 points)
matic) 2) SSG output: –90dBm (7.08µV)
Mod: 1kHz
Dev: ±1.5kHz
36
TENTATIVE
U
( )
ADJUSTMENT
Measurement
Test-
Unit Terminal Unit
equipment
Deviation ANT
meter
Deviation ANT
meter
Oscillo-
scope
AG
AF VTVM
ANT
MIC
ANT
Measurement
Test-
Unit Terminal Unit
equipment
SSG ANT
Oscillo- Ext.SP
scope
AF VTVM
Distortion
meter
Adjustment
Parts Method
FPU The Deviation of ±0.4dB
20Hz frequency
is fi xed. (FL=30,
FLC=35, FC=40,
FCH=45, FH=50)
Change the 1kHz
adjustment value to
become the same
deviation of 20Hz
within the specifi ed
range.
2.2kHz ±0.05kHz
(According to the
large +, –) Note:
FPU auto input 1kHz/50mV
Check 1.1kHz~1.8kHz
FPU 0.35kHz ±0.05kHz
0.35kHz ±0.05kHz
1.5kHz ±0.05kHz
1.5kHz ±0.05kHz
Adjustment
Parts Method
FPU Auto tuning
Specifi cations / Remarks
Specifi cations / Remarks