Kenwood TK-8360 Service Manual page 35

Common Section
Item Condition
1. Setting 1) Power supply voltage
DC power supply terminal
: 13.6V
2. Receive 1) (Auto tuning)*
Assist
Voltage
(Automatic)
3. Transmit 1) (Auto tuning)*
Assist 2) Transmit
Voltage
(Automatic)
4. VCO Lock 1) TEST CH: Low, Low', Center,
Voltage High', High (5 points)
Check
• RX
• TX 2) TEST CH: Low, Low', Center,
High', High (5 points)
3) Transmit
*: At test mode, click [Tune Assist Voltage] button in test mode dialog box, then start automatic adjustment of Receive/Transmit assist voltage.
Transmitter Section
Item Condition
1. Frequency 1) TEST CH: TX center
2) Transmit
2. High Trans- 1) TEST CH: Low, Low', Center,
mit Power High', High (5 points)
2) Transmit CH: TX Low'
• TK-8360
• TK-8360H/
8360H(U)
3. Mid Transmit 1) TEST CH: Low, Low', Center,
Power High', High (5 points)
2) Transmit CH: TX Low'
TK-8360H/
8360H(U)
only
4. Low Trans- 1) TEST CH: Low, Low', Center,
mit Power High', High (5 points)
2) Transmit CH: TX Low'
TENTATIVE
ADJUSTMENT
Measurement
Test-
Unit Terminal Unit
equipment
Power
meter
Power TX-RX LV
meter
DVM
Measurement
Test-
Unit Terminal Unit
equipment
Frequency ANT
counter
Power
meter
Ammeter
TK-8360/8360H/8360H
Adjustment
Parts Method
FPU "Voltage Level" indi- 2.5V±0.2V
cator on PC window
shows VCO lock
voltage.
Change the adjust-
ment value to get
VCO lock voltage
within the limit of
the specifi ed volt-
age.
Note:
Confi rm the VCO
lock voltage approxi-
mately 3 seconds
after the adjustment
value is changed.
Check 2.5V±0.2V
Adjustment
Parts Method
FPU Adjust to center Within ±100Hz
frequency
25W ±1.0W
8.0A or less
45W ±2.0W
14.0A or less
25W ±1.0W
8.0A or less
5W ±0.5W
4.0A or less
U
( )
Specifi cations / Remarks
Specifi cations / Remarks
35