Part 2. Basic Function Of Airplane; Quick Guide Of Acro Basic Menu - RadioLink AT10II Instruction Manual

Press and hold MODE BUTTON for one second to open programming menus. Press MODE
BUTTON to switch between BASIC and ADVANCE. Press MODE BUTTON to scroll between
conditions in certain functions.
END BUTTON:
Press END BUTTON to return to previous screen. Closes functions back to menus, closes menus
to start-up screen.
PUSH BUTTON:
Press PUSH BUTTON to select a function.
Turn DIAL:
Turn DIAL clockwise or counterclockwise to scroll through choices within an option of a function
Warning and error display
When the transmitter is powered on, warning or error may happen by the following probability:
1. Battery low voltage alarming
Lithium battery 2S-4S can fit for the transmitter, warning voltage can be self-set according to
different battery.
Setting step: power on the transmitter, press and hold MODE one second to enter basic menu,
and press PUSH to enter PARAMETER. Choose TX ALARM by DIAL and PUSH to change relative
data. Suggested min voltage is not less than 7.4V.
When the transmitter voltage is less than the setting voltage, it will beep till the transmitter is
powered off. Most important thing is to land your model plane when the transmitter alarms.
******WARNING!!!******
2. Mixing alarm
When the transmitter alarms mixing, it means at least one mixed switch is active. And when it is
inactive, warning will stop then. When the transmitter is powered on, in different model type, mixing
switch is shown as below:
ACRO: throttle cut, idle down, snap roll, air brake
GLID: butterfly, condition
HELI: throttle cut, throttle lock, speed up
If the warning continues even the related switch is set OFF, probably it is because some programs
mixed by one switch and status OFF reversed. Now you need to set mixing alarm again by DIAL.

PART 2. BASIC FUNCTION OF AIRPLANE

Please pay attention that the (BASIC) menu is suitable for all type models (airplane, helicopter,
glider, multicopter). The motor cut will be introduced in Glider (Basic) Menu, except Idle down
&Throttle cut. Helicopter Basic Menu include some extra function (swash plate tilting, throttle and
pitch curves and the tail rotor anti torque mixing under normal flight model) will be discussed in
Helicopter section.
2.1 A QUICK GUIDE OF ACRO BASIC MENU
TX LOW POWER！
Start up screen
13
Radiolink Electronic Ltd
www.radiolink.com