Table of Contents
Advertisement
Getting started
Battery installation and charging
2. Align the cover flat against the battery compartment, then slide it upwards
until it clicks into place.
CHARGE light
After you install your telephone or power returns following a
power outage, the handset and telephone base will prompt
you to set the date and time. For instructions, see
Set date/time on page 15 or page 26. To skip setting the date
and time, press
the telephone base.
IMPORTANT INFORMATION
•
Use only the supplied rechargeable battery or replacement battery (model BT183342).
To order, visit our website at
1 (800) 222-3111
•
If you do not use the handset for a long time, disconnect and remove the battery
to prevent possible leakage.
3. Charge the handset by placing it face
forward in the telephone base or charger.
The CHARGE light on the handset is on
during charging.
/CANCEL on the handset or CANCEL on
OFF
www.telephones.att.com
.
In Canada, dial
1 (866) 288-4268
10
SET DATE
MM/DD/YY
p
q
SET TIME
HH:MM --
p
q
or call
.
Advertisement
Table of Contents
