Panasonic Viera TC-P42X3L Operating Instructions Manual page 24

Screen Display
• Off
• On
R-Gain
G-Gain
B-Gain
R-Cutoff
G-Cutoff
B-Cutoff
Reset to
Defaults
Gamma
Reset to
Defaults
Side Panel
• Off
• Low
• Mid
• High
16:9 Overscan
• Off
• On
H-Size
• Normal
• Extended
Colour Matrix
• SD
• HD
DVI Input Setting
• Normal
• Full
Pixel Orbiter
• Auto
• On
Scrolling Bar
Reset to Defaults
∗ 1 : PC input mode only
24
Turns the screen off when you select [Off]
•
The sound is active even if the screen turns off.
•
Press any buttons (except Standby) to turn the screen on.
•
This function is effective in reducing power consumption when listening
to the sound without watching the TV screen.
Adjusts the white balance of bright red area
Adjusts the white balance of bright green area
Adjusts the white balance of bright blue area
Adjusts the white balance of dark red area
Adjusts the white balance of dark green area
Adjusts the white balance of dark blue area
Press the OK button to reset to the default White Balance
Switches the gamma curve
• S Curve /
•
Please note the numerical values are reference for the adjustment.
1.8 / 2.0 / 2.2
/ 2.4 / 2.6
Press the OK button to reset to the default Gamma
Increases the brightness of the side panel
•
The recommended setting is [High] to prevent panel "image retention".
[On] : Default - Image is overscanned by ~5% beyond the edge of the
screen to hide edge video noise
[Off] : Displays image in its original size including edge video noise such
as lines, dashes, dots etc.
•
Applicable for video signals when TV aspect is set to [16:9]
•
Memorised separately for SD and HD channels / signals
Switches over horizontal scanning size
Available only with 480p input on video signals in a natural colour from
digital equipment connected to AV1 / AV2 component or HDMI1 / HDMI2
terminals. Select SD or HD to adjust suitable colour parameters for SD
(Standard definition) or HD (High definition)
•
SD: Input signal is a normal TV system
•
HD: Input signal is a high definition system
Changes the black level in the image for HDMI input mode with DVI input
signal manually
•
When the DVI input signal from the external equipment, especially from PC,
is displayed, the black level may not be suitable. In this case, select [Full].
•
The black level for HDMI input signal will be adjusted automatically.
•
For HDMI input mode with DVI input signal only.
Selects the mode for wobbling of the image to prevent panel "image
retention"
[Auto]: Automatically works only for the appropriate images and you
rarely recognise the wobbling.
Scrolls the vertical bar to prevent panel "image retention"
•
Press the OK button to start scrolling and press any buttons (except
Standby) to exit this mode.
Press the OK button to reset the present Picture Viewing Mode of the
selected input to the default settings.